Digital Multimeter / Rack-mount / Industrial / DC

digital multimeter / rack-mount / industrial / DC

NI PXI-4071

digital multimeter / rack-mount / industrial / DC

Contact us for advice solutions and equipment provider

Display:

digital
Form:

rack-mount
Other characteristics:

DC, voltage, current, resistance

Applications:

industrial
Voltage:

Min.: 100 mV

Max.: 1000 V
Current:

Min.: 0.001 mA

Max.: 3 A

Resistance:

Min.: 100 Ohm

Max.: 5000000000 Ohm

The NI PXI-4071 PXI is the industry's most accurate 7?-digit digital multimeter. It features voltage measurements of ?10 nV to 1000 VDC (700 VAC), 8DC current ranges with sensitivity down to 1pA, Resistance measurements from 10?? to 5G?, ?500 VDC/Vrms common-mode isolation, and 1.8 MS/s isolated, 1000 V waveform acquisition

Để lại bình luận

View catalogue Go to the NATIONAL INSTRUMENTS website for more information

Products relative

Voltage measuring devices

high-voltage detector / silicon / electronic

high-voltage detector / silicon / electronic

The ROHM voltage detector IC series are reset IC with highly accurate detection voltage of ?1% , low current consumption, small thin packages and wide range of detection voltage. They can be used for every kind of application equipped ...

high-voltage probe

high-voltage probe

The Chauvin Arnoux SHT40kV is a hand held high voltage probe. The SHT40kV probe is designed to measure voltages referenced to earth, 40 kVDC or peak and up to 28 kVAC (50/60 Hz) and suitable to be used with any existing multi-meter. ...

voltage detector

voltage detector

600 V, CAT IV | C.A 740N, C.A 760N

Chauvin Arnoux test measurement voltage absence testers (VATs) C.A 740N and C.A 760N check for the absence of voltage in compliance with Edition 2 of the IEC 61243-3 standard workplace legislation on the protection and safety of electrical ...

step and contact voltage measurement device

step and contact voltage measurement device

The HT2055, generally composed of a station and a meter-designed model, is generally designed to perform step-contact voltage measurements on electrical installations involving HV power station (TN system, electrical substation) with ...

AC voltage detector

AC voltage detector

100 - 1000 V | HT20s

The HT20 is a pen voltage detector engineered by HT Instruments. It is constructed in compliance to IEC/EN61010-1 safety standard in CAT IV 1000V. The device detects AC voltage from 100V to 1000V, at an operating frequency rate of ...

voltage detector / non-contact / with working light

voltage detector / non-contact / with working light

The FLIR VP52 is a tough, CAT IV-rated Non-Contact Voltage Detector featuring a combination of alerts tactile vibration and red LED alarms, a powerful LED flashlight, and versatile voltage sensitivities. We engineered the FLIR VP52 to ...

medium-voltage detector

medium-voltage detector

In just one or two seconds, an operator can find out whether if it is secure to work around regions such as: transformer gear and circuit splitter housings, power ground wires or freshly-driven earth rods transportable dwellings, metal ...

temperature measuring device / voltage / moisture / power

temperature measuring device / voltage / moisture / power

Profitest PRIME

PROFITEST PRIME The first All-in-One Tester for electrical equipment, machinery, industrial machinery, wind turbines and many other fields of applications. Thanks to the wide range of potential applications and versatile test ...

Current measuring devices

digital clamp ammeter / portable / with power quality and harmonic analyzer / voltage

digital clamp ammeter / portable / with power quality and harmonic analyzer / voltage

Current: 1000 A

digital clamp ammeter / portable / Bluetooth / with power quality and harmonic analyzer

digital clamp ammeter / portable / Bluetooth / with power quality and harmonic analyzer

Voltage: 0 V - 1000 V
Current: 0 mA - 1000 mA

digital clamp ammeter / portable / AC / voltage

digital clamp ammeter / portable / AC / voltage

max. 600 A | HT4010

Voltage: 0 V - 600 V
Current: 0 A - 6000 A

digital clamp ammeter / portable / voltage / current

digital clamp ammeter / portable / voltage / current

max. 400 A AC | HT4012

Current: 0 A - 400 A

eddy current probe / for NDT

eddy current probe / for NDT

max. 200 A AC, 750/1 000 V AC/DC | HT7011

The Olympus eddy current probes are comprised of acquired brands by Nortec and NDT Engineering. Over 10,000 standard and custom designed eddy current probes, accessories and standard references are available. Numerous standard design ...

eddy current probe / manual / flexible / for surface inspection

eddy current probe / manual / flexible / for surface inspection

max. 200 A AC, 750/1 000 V AC/DC | HT7011

Olympus's Surface Probes are highly useful in inspecting and detecting near-surface, as well as surface cracks. These basic-purpose probes consist of coils manufactured for greater frequencies with a relatively smaller diameter housing. ...

clamp ammeter without display / portable / AC / DC

clamp ammeter without display / portable / AC / DC

CHAUVIN ARNOUX PAC 20, 21 and 22 are professional AC/DC ammeter clamps. The PAC 2x series is based on the principle of hall-effect. It allows measurement of up to 1,400A DC and 1,000A AC. The PAC series are used for power measurement. ...

clamp ammeter without display / portable / current

clamp ammeter without display / portable / current

500 µA - 400 A | B102

Current: 400 A

Power measuring devices

electric energy meter / DIN rail / single-phase / three-phase

electric energy meter / DIN rail / single-phase / three-phase

Current: 25, 32, 65, 6 A
Voltage: 230, 400 V

electric energy meter / DIN rail / three-phase

electric energy meter / DIN rail / three-phase

The CDTs by Enerdis is considered one of the best because it is very convenient and flexible. It allows the consumer to read the data remotely using the WinThor software and this advanced software is also used to supervise and manage ...

electric energy meter / wall-mounted / with LCD display

electric energy meter / wall-mounted / with LCD display

The Chauvin Arnoux group subsidiary ENERDIS has created the ULYS product range. This series consists of six different electrical energy meters for the LV and MV that are in complete accordance with IEC 61036 Class 1 product standards. ...

electric energy meter / wall-mounted / digital / single-phase

electric energy meter / wall-mounted / digital / single-phase

Memo 3M Enerdis

This range of energy meters feature 3 primary characteristics reliability, compactness and accuracy. They can now be ordered in a MID Class B Variant, which is is ideal for rebilling electrical energy particularly on private networks. ...

power transducer

power transducer

The transducers in this product series are able to convert reactive and active power into low level DC analog signals. In most situations, these devices are installed upstream of the analog or digital panel meters, recorders, programmable ...

cement analyzer / power quality / portable / measuring

cement analyzer / power quality / portable / measuring

CW240 power meter is a one-stop solution for improving energy efficiency, finding areas for improvement and assessing equipment lifecycles. This device is capable of providing in-depth information about an item of equipment, or even an ...

modular power meter

modular power meter

Most advanced optical power and energy meters in the market Patented self-centering zoom bar graph and Auto-Scaling Strip Chart Windows 7 and XP, 32 and 64 bit compatible software Superb sensitivity, accuracy, and speed 10 fA resolution ...

high-performance power meter

high-performance power meter

Drop-in replacement of legacy bench top 1830-C USB2.0 (1830-R) and additional GPIB/RS-232 (1830-R-GPIB) Interfaces DC power measurements in the 1 pW?2 W range CE and RoHS compliant A chirping audible tone for alignment Hot swappable among ...